 |
|
 |
|
Below are basic operation guidelines for the BACTRACK Breathalyzer. For more details instructions and explanations, please read the BACTRACK S50 Breathalyzer Owners’ Manual.
 |
STEP 1
Insert a disposable mouthpiece.
It is recommended to insert a new mouthpiece before each test. |
 |
 |
STEP 2
Press the POWER button to turn on the BACTRACK. The total number of tests performed since the last service is briefly displayed and then a countdown
sequence begins. |
|
 |
STEP 3
When the countdown approaches 10, begin to inhale a deep breath. |
|
 |
STEP 4
When the countdown reaches zero, the READY light will flash and two beeps will sound. Blow hard, continuously, for five full seconds. While a user is blowing, the BACTRACK will sound a continuous tone. Keep blowing until two beeps are heard. |
 |
STEP 5
When finished taking a breath sample, the BACTRACK will circle the outer LED fields for three seconds while analyzing the breath sample. |
 |
STEP 6
Once the sensor technology has analyzed the breath sample, the estimated BAC (Blood Alcohol Content) value is flashed on the screen. |
| The test result will be displayed for 10 seconds. Then the BACTRACK will beep five times before powering off.
If the BAC reading is over 0.05%, the red WARN lamp
will illuminate and a rapid beep alarm will sound.
The displayed result is an estimate of the test subject’s BAC.
A breath alcohol tester cannot determine the exact BAC in the blood of the test subject. Correlation between BrAC and BAC depends on many factors, such as temperature and health conditions. Therefore, only use this device as a tool to screen for the presence of alcohol.
Many people consider a 0.02% or greater a positive test for alcohol in “zero tolerance” screening. Most states have 0.08% as the legal BAC limit for tasks such as operating a motor vehicle. Some states prohibit driving commercial vehicles or any vessel with a 0.04% BAC or higher. Many states and countries prosecute individuals for driving under the influence at any level. |
|
 |
ALERTS
|
 |
 |
Battery Low
The battery power is low.
Please replace the batteries. |
|
 |
Flow Error
The breath sample was not sufficient.
Please repeat the testing process, ensuring a continuous, 5 second breath sample. |
|
 |
Time Out
If the user does not blow within 10 seconds, the unit displays [Out] and shuts down. |
|
 |
Calibration
The unit requires recalibration or maintenance.
Please refer to the Verification and Calibration section of this manual. |
|
| Powering Off
To turn the power off at any time, press power button. |
|
|
Compact size and sleek design - easily fits into a pocket or purse. |
|
Begin testing your alcohol level in a matter of seconds and get instant results. |
|
BACTRACK technology provides professional accuracy at an affordable price. |
|
|
 |
|
 |
